The GCM-01-M02 is a specialized control unit designed for the automation of swing gates. It manages two DC motors (up to 24V) and provides advanced features like soft start/stop, obstacle detection, and Bluetooth-based configuration via an Android application.
The system is designed for high reliability, featuring overcurrent protection, dedicated inputs for safety photocells, and support for external control commands (Open, Close, Stop).
| Parameter | Value / Detail |
|---|---|
| Supply Voltage | 230V AC (Internal Transformer) |
| Motor Voltage | 12V / 24V DC |
| Max Motor Power | 80W per channel |
| Max Current Protection | 10A (Adjustable via Config) |
| Accessory Output | 12V DC (Max 500mA) |
| Radio Frequency | 433.92 MHz |
| Working Temperature | -20°C to +55°C |
| Protection Rating | IP54 (In enclosure) |
The main power supply is connected to the primary AC terminals. Motors M1 and M2 are connected to the high-power DC terminals. Ensure the polarity matches the desired opening direction.
The unit features a dedicated terminal block for safety and manual control:
The board is protected by two main fuses: a 2A fuse for the logic/accessory circuit and a 10A fuse for the motor power circuit.
To configure parameters, the HC-05/06 Bluetooth module must be connected to the dedicated header. Jumper J12 must be shorted to enter configuration mode.
The "ASEC Gate Config" app allows you to adjust:
| Terminal | Function |
|---|---|
| AC-IN | 230V Mains Power |
| MOT 1 (+/-) | Motor 1 Output |
| MOT 2 (+/-) | Motor 2 Output |
| LAMP | Signal Lamp Output (12/24V) |
| PH1 / PH2 | Photocell Inputs |
| OPN / CLS / STP | Command Inputs |
